Cisco 7925G - Unified Wireless IP Phone VoIP Manuel d'administration - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'administration pour {nom_de_la_catégorie} Cisco 7925G - Unified Wireless IP Phone VoIP. Cisco 7925G - Unified Wireless IP Phone VoIP 14 pages. Wavelink avalanche management console
Également pour Cisco 7925G - Unified Wireless IP Phone VoIP : Fiche technique (8 pages), Notes de mise à jour (16 pages), Manuel de l'utilisateur (28 pages), Manuel des accessoires (20 pages), Manuel des accessoires (13 pages), Manuel d'administration (19 pages), Manuel de l'utilisateur (10 pages), Manuel de l'utilisateur (16 pages), Manuel rapide (14 pages), Manuel d'administration (23 pages), Manuel d'installation (21 pages)

Wavelink Avalanche Server

Procedure

Step 1

Turn on the phone.

Step 2

Verify that the phone is installed with the required firmware version and is registered to Cisco Unified

Communications Manager.

Step 3

Choose SETTINGS > System Configuration > Wavelink.

Step 4

To unlock the phone, press **#.

Step 5

In the Alternate Wavelink Server option, choose Yes.

Step 6

Enter the IP address of the Wavelink server, and press Save.

Set Up Wavelink Server Address from Phone Web Page

To assign the Wavelink server using the phone web page, follow these steps.

Procedure

Step 1

From the phone web page, choose Wavelink Settings from the left pane.

Under Wavelink Settings, make sure that the server is enabled.

Step 2

Click Use the following Server and enter the IP address of the server.

Step 3

Click Save.

Set Up and Use CU

This section describes the tasks for configuring and using the CU from the Wavelink Management Console.

Note

The CU is labeled as 7921G but the CU works for all 792X phones.

To set up and use the CU from the Wavelink Management Console, perform the following tasks.

Procedure

Step 1

Assign attributes for the phone. For more information, see

Step 2

Install the CU on Wavelink. For more information, see

Step 3

Update the configuration files. For more information, see

Step 4

Update the phones. For more information, see

Install CU File, on page

Phone Attributes Setup, on page

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide

Set Up Wavelink Server Address from Phone Web Page

Phone Attributes Setup, on page

Update Configuration Files, on page