Siemens SIMATIC S7-1200 Manuel - Page 32

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Siemens SIMATIC S7-1200. Siemens SIMATIC S7-1200 40 pages. Controlling several fans (ebm-papst) via modbus rtu
Également pour Siemens SIMATIC S7-1200 : Manuel (30 pages), Manuel d'utilisation (36 pages), Programmation de la sécurité Manualline (48 pages), Manuel (17 pages), Manuel (31 pages), Manuel (49 pages), Manuel (20 pages)

Imprimer la page

5 Installation and Commissioning

5.3 Commissioning

No.

If you want to use the simulation in TIA Portal, you have to set the PG/PC interface in the control

panel of your development system (this step is not necessary if you are using a real operator panel

instead of the simulation).

Go to Control Panel > All Control Panel Items >

Select the access point of the application (S7ONLINE (STEP 7)) and the interface parameter

assignment (network card) you are using. Select the one with the ...TCPIP.Auto.1 extension.

Select OK to close the window.

If you are using a real operator panel, download HMI_1 to the KTP600.

When the "Extended download" window appears, proceed in the same way as when downloading

the PLC (see step 5 of this table).

After successful downloading, the configured start screen appears on the operator panel.

5.3

Commissioning

A specific commissioning routine is not required. Provided that you have performed

the hardware and software installation described above, you only have to energize

the power circuit for the SINAMICS V20 if this has not already been done. The next

steps are described in the following chapter, 6 "Operation of the Application".

SINAMICS V20 at S7-1200/1500 via USS

Entry ID: 109480894,

V1.0,

KTP600

09/2018

Action