Cisco 7941G - Unified IP Phone VoIP Manuel du téléphone - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du téléphone pour {nom_de_la_catégorie} Cisco 7941G - Unified IP Phone VoIP. Cisco 7941G - Unified IP Phone VoIP 30 pages. Unified communications manager 9.0 (sccp and sip)
Également pour Cisco 7941G - Unified IP Phone VoIP : Manuel de l'utilisateur (21 pages), Manuel de l'utilisateur (25 pages), Fiche technique (7 pages), Référence rapide (2 pages), Manuel de l'utilisateur (4 pages), Manuel de l'utilisateur (4 pages), Manuel de l'utilisateur (13 pages), Manuel d'administration (12 pages), Manuel de l'utilisateur (13 pages), Manuel de l'utilisateur (13 pages), Manuel de l'utilisateur (6 pages), Manuel d'administration (16 pages), Dépannage et maintenance (27 pages)

Imprimer la page
Cisco 7941G - Unified IP Phone VoIP Manuel du téléphone

Connecting Your Phone

IMT will likely initially connect your new Cisco Unified IP Phone to the APU IP telephony network. If
your phone needs to be moved for any reason, refer to the figure and table below to connect your
phone.
1
DC adaptor port (DC48V) – Not used
2
AC-to-DC power supply – Not used
3
AC power cord – Not used
4
Network port (10/100 SW) – Plug into data jack
Connecting Your Phone
Your Cisco phone is powered by and runs off of a data connection. Your phone should be plugged
into a data jack (see 4 above), NOT a phone jack. Your computer can then run off of the data
connection through the phone by plugging your computer into the phone (see 5 above).
Adjusting the Footstand
To change the angle that your phone sits on your desk, adjust the footstand while pressing the
footstand button.
Access port (10/100 PC) – Plug into
5
computer data port
6
Handset port
7
Headset port
8
Footstand button
3