Siemens dishwasher Manuel d'utilisation - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Siemens dishwasher. Siemens dishwasher 30 pages. Dishwasher
Également pour Siemens dishwasher : Manuel d'utilisation (29 pages), Manuel d'utilisation (30 pages), Manuel d'utilisation (30 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (26 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (26 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (32 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (34 pages), Manuel d'utilisation (34 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (34 pages), Manuel d'utilisation (26 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (31 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (24 pages), Manuel d'utilisation (28 pages), Manuel d'utilisation (28 pages)

Imprimer la page
Siemens dishwasher Manuel d'utilisation
en

Warm water connection *

* depending on model
The dishwasher can be connected to cold
or hot water up to max. 60 °C.
Connection to hot water is recommended
if the hot water can be supplied
by energetically favourable means
and from a suitable installation, e.g. solar
heating system with circulation line.
This will save energy and time.
The hot water setting :
to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water
temperature (temperature of the incoming
water) of at least 40 °C and no more than
60 °C.
It is not recommended to connect
the appliance to hot water if the water
is supplied from an electric boiler.
Setting hot water:
– Open the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button )" until : ... is
indicated on the digital display.
– Release both buttons.
The LED for button # flashes and the
digital display 8 displays the factory
setting :
.
– Press programme button # until the
factory set value
the digital display 8.
To change the setting:
– By pressing the 3 button, you can
switch the hot water setting off :
on :
.
– Press START button )".
The set value is saved.
– Close the door.
26
allows you
:
is indicated on
or

Electrical connection

– Connect the appliance to an alternating
current only, ranging from 220 V to
240 V and 50 Hz or 60 Hz via
a correctly installed socket with
protective earth conductor. See rating
plate for required fusing 9B.
– The socket must be near the appliance
and freely accessible following
installation.
– The connection may be modified by
technicians only.
– A power cord extension may be
purchased from customer service only.
– Use only a residual current operated
circuit-breaker which features the
symbol ‚. Only this extension
guarantees compliance with the
currently valid regulations.
– The appliance features a water
damage protection system. Please
note the system will not function
unless the power supply is connected.

Removing the appliance

Also observe the sequence of worksteps
here.
– Disconnect the appliance from the
power supply.
– Turn off the water supply.
– Disconnect the waste water and fresh
water connections.
– Loosen the fastening screws under the
worktop.
– If fitted, remove the base panel.
– Pull out the appliance, carefully pulling
the hose behind.