Siemens SN 66M094 Manuel d'utilisation - Page 29
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Siemens SN 66M094. Siemens SN 66M094 40 pages.
Imprimer la page
Fault
Utensils not dry.
Plastic utensils not dry.
Cutlery not dry.
Appliance interior wet after
rinse cycle.
Downloaded from DishWasher-Manual.com Manuals
Cause
No or too little rinse aid
in the dispenser.
Programme selected without
drying.
Water collecting in depressions
on the utensils and cutlery.
The combined detergent used
has a poor drying performance.
Intensive drying to increase
drying not activated.
Utensils were removed too early
or drying process had not ended
yet.
The eco rinse aid used has a poor
drying performance.
Special properties of plastic.
Cutlery not arranged properly
in the cutlery basket.
Cutlery not arranged properly
in the cutlery drawer.
No appliance fault.
Fault, what to do?
Remedial action
Refill rinse aid.
Select programme with drying (see
Overview of programmes, Programme
sequence).
Arrange utensils in a sloping position,
arrange affected utensils as sloping
as possible.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Activate intensive drying (see Operating
the appliance)
Wait until program ends or wait until 30 min
after program ends before removing
utensils.
Use a proprietary rinse aid. Eco products are
much less effective.
Plastic has a lower heat storage capacity
and therefore dries less well.
Separate cutlery if possible, prevent contact
points.
Arrange cutlery properly and separate if
possible.
On account of the "Condensation drying"
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.
en
29