Siemens SX Series Instructions de fonctionnement - Page 11

Parcourez en ligne ou téléchargez le pdf Instructions de fonctionnement pour {nom_de_la_catégorie} Siemens SX Series. Siemens SX Series 38 pages. Dishwasher
Également pour Siemens SX Series : Manuel d'utilisation (38 pages), Manuel d'utilisation (42 pages), Manuel d'utilisation (42 pages), Manuel d'utilisation (44 pages), Manuel d'utilisation (46 pages), Manuel d'utilisation (44 pages), Manuel d'utilisation (42 pages), Manuel d'instruction (48 pages), Manuel d'utilisation (40 pages), Manuel d'utilisation (42 pages), Manuel d'utilisation (44 pages), Manuel d'utilisation (40 pages)

Imprimer la page
Siemens SX Series Instructions de fonctionnement

Rinse aid

a i d
R i n s e
As soon as the rinse-aid refill
indicator )" is lit on the fascia, there
is still a rinse-aid reserve of 1-2 rinsing
processes. Refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH,
26° Clarke, 3.7 mmol/l) only. If
the water hardness is over 21° dH,
rinse aid must be used.
1. Open the dispenser 1j by pressing
and lifting the plate on the cover.
2. Carefully pour rinse aid up
to the max. mark in the filler opening.
3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.

Setting amount of rinse aid

The amount of rinse aid dispensed can
be set in 4 stages. Accordingly 0, 1, 2
or 3 displays are lit (see water hardness
table).
Factory setting: 1.
Do not change the amount of rinse aid
unless streaks (select lower setting)
or water stains (select higher setting)
are left on the utensils.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down button > P and press
START button h until the dry
display ` and salt refill
indicator )* flash.
4. Release buttons.
5. Keep pressing button > P until
the rinse aid refill indicator )"
flashes.
The rinse aid refill indicator )"
flashes and the display # is lit
(= Setting 1).
To change the setting:
1. Press the button < H until
the required setting has been
selected.
2. Press START button h.
The displays ` and )" go out.
The selected setting is saved.
3. Close the door.
PD[
Rinse aid
en
11