Siemens SX Series Manuel d'utilisation - Page 23

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Siemens SX Series. Siemens SX Series 40 pages. Dishwasher
Également pour Siemens SX Series : Instructions de fonctionnement (38 pages), Manuel d'utilisation (38 pages), Manuel d'utilisation (42 pages), Manuel d'utilisation (42 pages), Manuel d'utilisation (44 pages), Manuel d'utilisation (46 pages), Manuel d'utilisation (44 pages), Manuel d'utilisation (42 pages), Manuel d'instruction (48 pages), Manuel d'utilisation (42 pages), Manuel d'utilisation (44 pages), Manuel d'utilisation (40 pages)

Imprimer la page
Siemens SX Series Manuel d'utilisation

Interrupting the programme

1. Open the door.
2. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
3. To continue the programme, switch
on the ON/OFF switch ( again.
4. Close the door.
T erminating the programme
T e r m i n a t i n g t h e p r o g r a m m e
(Reset)
1. Open the door.
2. Press START button h for
approx. 3 sec. until all displays go
out.
3. Close the door.
The remaining programme sequence
for draining the residual water takes
approx. 1 minute.

Changing the programme

When the START button h has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme
(Reset).
Operating the appliance

Intensive drying

The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Caution if utensils are delicate!)
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down button > P and press
START button h until the dry
display ` and salt refill
indicator )* flash.
4. Release buttons.
5. Keep pressing button > P until
the salt refill indicator )* and
"Check water supply" )2 flash.
6. Release buttons.
The displays )* and )2 flash.
To change the setting:
1. Press button < H until
the display # is lit (Intensive drying
on).
2. Press START button h.
The displays go out. The setting
is saved.
3. Close the door.
en
23