Cisco 7945G - Unified IP Phone VoIP Manuel d'installation - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco 7945G - Unified IP Phone VoIP. Cisco 7945G - Unified IP Phone VoIP 19 pages. Unified ip phone
Également pour Cisco 7945G - Unified IP Phone VoIP : Préparation de l'installation (17 pages), Manuel de l'utilisateur (4 pages), Manuel de l'utilisateur (23 pages), Manuel rapide (12 pages), Manuel rapide (15 pages), Manuel d'administration (6 pages), Manuel (9 pages), Manuel de référence rapide (3 pages), Dépannage et maintenance (25 pages), Manuel de l'utilisateur (42 pages)

Enable Headset Hookswitch Control

Procedure

Step 1

Choose Device > Phone and locate the phone you want to modify.

Step 2

In the Phone Configuration window, select Enable for Headset Hookswitch Control.

External Device Use

Cisco recommends the use of good quality external devices, such as speakers, microphones, and headsets that

are shielded (screened) against unwanted radio frequency (RF) and audio frequency (AF) signals.

Depending on the quality of these devices and their proximity to other devices, such as mobile phones or

two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take one or

more of the following actions:

• Move the external device away from the source of the RF or AF signals.

• Route the external device cables away from the source of the RF or AF signals.

• Use shielded cables for the external device, or use cables with a better shield and connector.

• Shorten the length of the external device cable.

• Apply ferrites or other such devices on the cables for the external device.

Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of external

devices, cables, and connectors. The system performs adequately when suitable devices are attached with

good quality cables and connectors.

In European Union countries, use only external headsets that are fully compliant with the EMC Directive

Caution

[89/336/EC].

Install Cisco Unified IP Phone

You must connect the Cisco Unified IP Phone to the network and to a power source before use. For the

description of how to connect the cables to the phone, see

Before you install a phone, even if it is new, upgrade the phone to the current firmware image.

Note

Before you use external devices, read

information.

Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified

Communications Manager 9.0 (SCCP and SIP)

Cisco Unified IP Phone Cable Installation, on page

External Device Use, on page 6

Cisco Unified IP Phones Installation

for safety and performance