Siemens iQ700 ER9A SD7 Series Manuel d'instruction - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Siemens iQ700 ER9A SD7 Series. Siemens iQ700 ER9A SD7 Series 16 pages.
Également pour Siemens iQ700 ER9A SD7 Series : Informations pour l'utilisation (17 pages), Instructions d'utilisation, d'installation et d'entretien (20 pages), Manuel de l'utilisateur et instructions d'installation (20 pages)
Imprimer la page
Getting to know your appliance
en
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to
work correctly. Do not swap the burner caps around.
Always remove the pan supports carefully. When
moving a pan support, the pan supports next to it may
also move.
Elements
1
Ignition plug
2
Thermocouple
3
Burner ring
4
Burner cup
5
Burner cap
Residual heat indicator
Every hotplate on the hob has a residual heat indicator
that indicates whether it is hot or warm.
If
appears in the display the hob is still hot. As the
•
hotplate cools down further, the display changes to
The display remains lit until the hotplate has cooled
sufficiently. Do not touch the respective hotplate if this
indicator is lit.
6
Inner flame on low power.
œ
Accessories
Depending on the model, the hob may include the
following accessories. These can also be acquired from
the Technical Assistance Service.
--------
Code
HZ298114 Additional espresso maker grid
HZ298105 Simmer Plate
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
.
Additional wok grid
Only suitable for use on wok
burners with two or three
flames. Only use cookware with
a diameter of more than 26 cm,
griddle plates, clay casserole
dishes, paella pans, cookware
with rounded base, etc.
To extend the service life of the
appliance, we recommend using
the additional wok grid.
Additional espresso maker
grid
Only suitable for use on the
smallest burner. Use cookware
with a diameter of less than
12 cm.
Simmer plate
This accessory part is only suita-
ble for simmering. It can be
used with the economy burner
or the standard-output burner. If
your hob has several standard-
output burners, we recommend
placing the simmer plate on the
rear or front-right standard-out-
put burner.
Place the accessory component
with the projections facing
upwards on the holder; never
place it directly on the burner.