Cisco 8800 Series Manuel principal de migration des microprogrammes - Page 11

After the reboot, the phone has the transitional load installed. You will see "Configuration check in progress" and you may see a

warning "Failed to downloaded configuration data. Contact your administrator." DO NOT CLICK RETRY.

Ignore this warning as it only pertains to Bulk Provisioning. Bulk provisioning is covered in the Appendix. Move to the next step.

11. Determine the IP Address of your phone:

•

Push the Applications button

12. Type the following into your web browser:

13. In your web browser, navigate to Voice -> Provisioning.

14. Scroll down to "Firmware Upgrade" and paste the following into the "Upgrade Rule".

Upgrade Rule:

http://CUCM_ip_address:6970/sipxxxx.11-2-3MPP-398.loads

Unified CM and sipxxxx is the appropriate phone load (either sip78xx or sip88xx). The filename is the same as the file you entered in

Step 8.

(This is a normal MPP image that can be registered to approved 3

Transition Load Authorization Rule:

Press Submit All Changes

Example:

Note: The $MAU is a macro. The phone expands the macro $MAU to its own MAC address in all uppercase and transmits the

expanded request across the wire. The full path of the license file is listed below as reference.

-> Status -> Network Status -> IPv4

http://ip_address_of_phone/admin/advanced

http:// CUCM_ip_address:6970/$MAU.lic

where CUCM_ip_address is the IP address of the

party call control systems).

Page 11 of 30