Cisco 8832 Manuel - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Cisco 8832. Cisco 8832 30 pages. Masergy ip conference phone
Également pour Cisco 8832 : Manuel principal de migration des microprogrammes (31 pages), Manuel de l'utilisateur (20 pages), Manuel de démarrage rapide (2 pages), Manuel d'installation (39 pages), Manuel de démarrage rapide (16 pages), Manuel d'entretien (9 pages), Démarrage rapide (2 pages), Paramètres (14 pages), Manuel de démarrage rapide (2 pages), Manuel de reconfiguration (2 pages), Démarrage rapide (2 pages), Manuel (30 pages)

Install the Conference Phone in Daisy Chain Mode

with the units or a pair of wireless microphones with the units, but not a mixed combination of the microphones.

When a wired microphone is connected to one of the units, it unpairs any wireless microphones that are

connected to the same unit. Whenever there is an active call, the LEDs and the menu options on the phone

screen of both units are synchronized.

Install the Conference Phone in Daisy Chain Mode

The daisy chain kit contains a Smart Adapter, a short LAN cable, two long, thicker USB-C cables, and a

shorter, thinner USB-C cable. In daisy chain mode, the conference phones require external power from an

electrical outlet. You must use the Smart Adapter to connect the phones together. The long USB-C cables go

to the phone and the short one goes to the power adapter. Refer to the following figure when you connect the

power adapter and the LAN port to the Smart Adapter.

Figure 7: Smart Adapter Power Port and LAN Port

You can use only one microphone per unit.

Note

You must use either two wired microphones or two wireless microphones with the phone, but not a mixed

combination.

The USB-C cable for the power adapter is thinner than the USB-C cables that connect to the phone.

Procedure

Step 1

Plug the power adapter into the electrical outlet.

Step 2

Connect the short, thinner USB-C cable from the power adapter to the Smart Adapter.

Figure 8: Smart Adapter USB Port Connected to the Power Outlet

Step 3

Required: Connect the Ethernet cable to the Smart Adapter and the LAN port.

Your Phone