Cisco 8832 Manuel d'entretien - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Cisco 8832. Cisco 8832 9 pages. Masergy ip conference phone
Également pour Cisco 8832 : Manuel principal de migration des microprogrammes (31 pages), Manuel de l'utilisateur (20 pages), Manuel de démarrage rapide (2 pages), Manuel (30 pages), Manuel d'installation (39 pages), Manuel de démarrage rapide (16 pages), Démarrage rapide (2 pages), Paramètres (14 pages), Manuel de démarrage rapide (2 pages), Manuel de reconfiguration (2 pages), Démarrage rapide (2 pages), Manuel (30 pages)

Perform a Factory Reset with the Phone Keypad

Note

When an administrator has set up emergency calls, the phone requests an updated location whenever the

administrator does the following actions:

• Registers the phone with the call server.

• Restarts the phone (phone is registered).

• Changes the network interface that is used for the SIP registration.

• Changes the IP address of the phone.

Perform a Factory Reset with the Phone Keypad

Use these steps to reset the phone to factory default settings using the phone keypad.

Procedure

Step 1

Unplug the phone:

• If using PoE, unplug the LAN cable.

• If using the power cube, unplug the power cube.

Step 2

Wait 5 seconds.

Step 3

Press and hold # and plug the phone back in.

When the phone boots up, the light on the mute button lights up.

Step 4

Press the 123456789*0# keys in sequence.

When you press a key, the light on the mute button flashes.

After you press these buttons, the phone goes through the factory reset process.

If you press the buttons out of sequence, the phone powers on normally.

Caution

Do not power down the phone until it completes the factory reset process, and the main screen appears.

Procedure

Step 1

Press Settings.

Step 2

Select Device administration > Factory reset.

Maintenance