Cisco 8851 Manuel - Page 27

Cisco IP Phone Accessories

You can also configure the parameter in the configuration file (cfg.xml) by entering a string in the following

format:

<Unit_n_Key_m>fnc=sd;ext=9999@$PROXY;vid=n;nme=xxxx

Step 4

Click Submit All Changes.

Add Call Park on a Key Expansion Module Line Key

You can add call park to a Key Expansion Module line key to enable the user to temporarily store calls to the

same phone to which the Key Expansion Module is connected or to store calls to a different phone. The user

can also unpark the call from the line key.

Before you begin

Access the phone administration web page. See

Procedure

Step 1

Select Voice > Att Console.

Step 2

Select a Key Expansion Module line key on which to enable the call park.

Step 3

Enter a string in this format:

For a private line, enter

fnc=park;sub=$USER@$PROXY;nme=CallPark-Slot1

For a shared line, enter

fnc=prk;sub=$USER@$PROXY;nme=Call-Park1;orbit=<DN of primary line>

where:

• fnc= prk means function=call park

• sub= 999999 is the phone to which the call parks. Replace 999999 with a numbers.

• nme= XXXX is the name displayed on the phone for the call park line key. Replace XXXX with a name.

You can also configure the line-specific parameter in the configuration file (cfg.xml). Enter a string in the

following format:

<Unit_1_Key_1_ ua="na">fnc=prk;sub=$USER@$PROXY;nme=CallPark-Slot1</Unit_1_Key_1_>

Step 4

Click Submit All Changes.

Configure the LCD Brightness for a Key Expansion Module

You can configure the brightness of the LCD display on the key expansion module from the Attendant Console

tab.

You can also configure the parameters in the phone configuration file with XML(cfg.xml) code.

Add Call Park on a Key Expansion Module Line Key

Access the Phone Web

Interface.

Cisco IP Phone Accessories