Bitzer BDC 380 (5F) (V) Manuel d'utilisation - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Bitzer BDC 380 (5F) (V). Bitzer BDC 380 (5F) (V) 10 pages. Bdc series air cooled condensers
Imprimer la page7.
Commissioning Instructions
•
Leak testing should be carried out in accordance with the current Refrigeration Code of Good
Practice*.
•
Following leak testing, the system should be evacuated using accepted refrigeration practices. The
vacuum pump should be connected to both the high and low pressure sides of the system with all shut-
off valves open.
•
Refrigerant charging should be carried out in accordance with the current Refrigeration Code of Good
Practice*.
•
Extreme care should be taken to avoid direct contact with liquid refrigerant (freeze burns).
•
Ensure the electrical wiring is in accordance with local electrical regulations and ensure fan motor
direction is correct.
8.
Maintenance Instructions
•
Buffalo Trident condensers require low maintenance apart from regular cleaning of the fin face.
Frequency is dependent upon the operating environment of the condenser.
•
It is recommended that fin surfaces are cleaned using a soft bristle brush and/or low pressure water,
taking care to avoid all electrical components (electrical power must be isolated prior to cleaning).
•
All fan motors contain bearings and are maintenance free.
9.
De-commissioning Instructions
•
Pump down refrigeration system into the receiver or suitable container. (As per Refrigeration Code of
Good Practice *)
•
Isolate power and remove electrical wiring (remove earth wire last) and associated components where
necessary.
•
Disconnect refrigeration piping and seal both the system and condenser connections (ensure that
positive/negative pressure does not exist in condenser prior to disconnection).
•
Condenser can now be removed from location (the use of lifting devices during removal is
recommended where applicable).
* Code of Good Practice produced in conjunction with AFCAM.
10.
Manufacturer
Our products are manufactured in compliance with applicable international standards and regulations. If you have
any questions about how to use our products or if you are planning special applications please contact:
BITZER Australia Pty Ltd
Buffalo Trident Division
25 Strzelecki Avenue
Sunshine VIC 3020, Australia
Tel.: +61 (0)3 8326 8200
Fax: +61 (0)3 9310 2520
www.bitzer.com.au
11.
Service Address
For local support please refer to our website www.bitzer.com.au for your nearest branch office.
HXO-501-1 AUS
9