Cisco 8865 Manuel - Page 36

Cisco IP Phone Accessories

You must also install an Ethernet jack for the telephone in the desired location if an Ethernet jack does not

currently exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular

telephone jack.

Procedure

Step 1

Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can

run the Ethernet network cable to a nearby jack.

Note

a) Hold the bracket on the wall, placing it so that the arrow on the back of the bracket is pointing up.

b) Use the level to ensure that the bracket is level and use a pencil to mark the screw holes.

c) Using a #2 Phillips-head screwdriver, carefully center the anchor over the pencil mark and press the anchor

into the wall.

d) Screw the anchor clockwise into the wall until it is seated flush.

e) Use the included screws and a #2 Phillips-head screwdriver to attach the bracket to the wall.

Figure 9: Bracket Installation

The following figure shows the bracket installation steps.

Step 2

Attach the phone bracket to the IP Phone.

Cisco IP Phone Accessories

If the jack is to be placed behind the phone, the Ethernet jack must be flush to the wall or recessed.

Cisco IP Phone Accessories