Cisco Catalyst 4000 Manuel de démarrage - Page 16

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Catalyst 4000. Cisco Catalyst 4000 31 pages. For cisco business edition 4000
Également pour Cisco Catalyst 4000 : Manuel (18 pages), Préparation de l'installation (11 pages), Manuel de démarrage rapide (8 pages), Manuel de l'utilisateur final (6 pages), Manuel de l'utilisateur final (6 pages)

Imprimer la page

—

For a serial connection, when you see the BIOS boot options, press Tab slowly and repeatedly (to prevent

the appliance from booting the currently installed version of the system). The LILO boot prompt appears.

For example:

LILO 22.8 boot:

System-5.4 System_Restore

Indicate that you want to restore the system:

—

For a keyboard and monitor connection, use the arrow keys to select

—

For a serial connection, type

The

prompt appears after the following choices:

boot

0. Load with standard console

1. Load with serial console

Select a display mode for the restore utility's interactive menu:

—

For a keyboard and monitor connection, type

—

For a serial connection, type

If you do not select a display mode, the restore utility defaults to the standard console after 30 seconds.

Unless this is the first time you have restored the appliance to this major version, the utility automatically loads

the last restore configuration you used. To continue, confirm the settings in a series of pages.

Press Enter to confirm the copyright notice.

What to Do Next



Continue with

Starting the Restore Utility Using Lights-Out Management

If you need to restore an appliance to factory defaults and do not have physical access to the appliance, you can

use LOM to perform the restore process. Note that if you want to use LOM to configure the initial setup, you must

preserve the network settings during the initial setup. Note also that you can use Lights-Out Management on the

default (

) management interface only.

eth0

Note:

Before you can restore an appliance using LOM, you must enable the feature; see

Management, page

To start the restore utility using Lights-Out Management:

At your computer's command prompt, enter the IPMI command to start the SOL session:

For IPMItool, type:

sudo ipmitool -I lanplus -H IP_address -U username sol activate

For ipmiutil, type:

sudo ipmiutil sol -a -V4 -J3 -N IP_address -U username -P password

Where

IP_address

authorized LOM account, and

password after you issue the

If you are using a Firepower device, type

Reboot the appliance as root user. For a Firepower device, type

The appliance reboots.

Cisco Firepower Management Center Getting Started Guide

System_Restore

and press Enter.

Using the Interactive Menu to Restore an Appliance, page

24.

is the IP address of the management interface on the appliance,

is the password for that account. Note that IPMItool prompts you for the

password

command.

sol activate

expert

Restoring a Firepower Management Center to Factory Defaults

at the prompt and press Enter.

and press Enter.

to display the shell prompt.

system reboot

and press Enter.

System_Restore

17.

Setting Up Lights-Out

is user name of an

username