Digital Matter G100 Iridium Hybrid Manuel d'installation et de test - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de test pour {nom_de_la_catégorie} Digital Matter G100 Iridium Hybrid. Digital Matter G100 Iridium Hybrid 8 pages.

Imprimer la page

G100 Iridium Hybrid

Installation and Test Guide

Rev 1.0 - 2 November 2018

Work through these steps in order, to check the device is connecting in and getting a GPS

fix. If an earlier step fails, the data in later steps may not be accurate. For example, if the

device is not connecting, the Battery Voltage will be based on older data, and will not be

current.

1. Check Last Connection (1) to check that the device connected recently. This means the

device is connecting to OEM. The time shown should be around about the time you inserted

the SIM and battery to power on the unit.

2. If device is connecting (1) check Last Commit (2) to see if it is sending data. If the connector

is set, it must be setup on the software platform that is meant to receive the data. e.g.

Telematics Guru.

3. Check the time of the last GPS update (3). It should be recent.

4. Check the battery level (4) is acceptable for the device type. It should be between 3.5-4.2V

(around 3.5V is flat)

4.3.1

Troubleshooting

If the device does not connect (1) check the following:

•

If the SIM card has been inserted correctly.

•

If external voltage is connected properly.

•

If the device is running, based on LED flashes

If the device does not commit (2) check the following:

•

If the device is setup on Telematics Guru. Contact your reseller for assistance

If the device does not update GPS (3) check the following:

•

The device has a clear view of the sky

Contact your reseller if you cannot resolve any issues.

You can now continue with the installation.

4.4 Wiring

The following (at minimum) is to be wired up

1. Power supply

2. Ignition

Refer to the G100 Harness definition (Section 6) for pin colours

4.5 Power Supply

1. Connect pin 24

2. Connect pin 12 (BLACK – Main GND) to vehicle earth

(RED – Voltage Input)

to 8-45V DC external power