Cisco CP-7910GSW Manuel de démarrage - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco CP-7910GSW. Cisco CP-7910GSW 34 pages. Getting started guide
Imprimer la page
Chapter 2
Installing the Cisco IP Phone 7910 Series
Installing the Phone and Connecting to the Network
AC adapter port
(optional power cube)
Step 1
Step 2
78-11443-02
Before installing the phone, read the safety warnings in the
section on page
2-1.
Refer to
Figure 2-1
for an overview about how to connect the
Cisco IP Phone 7910 Series telephone to your PC, the network, and a power
source. All ports are located at the rear of the phone base unit.
Figure 2-1
Cisco IP Phone 7910 Series Telephone Cable Connections
Network port
RS-232 port
(Cisco IP phone 7910+SW only)
Use this procedure to install the phone on a network that has already been
prepared to host the phone.
Connect an Ethernet cable to the network port on the phone.
Use the Ethernet cable supplied in the box with your Cisco IP phone. If you need
a longer cable, contact your system administrator.
Connect the handset to its port. Clip the cord into the slot to the right of the port.
Installing the Phone and Connecting to the Network
Cisco IP phone 7910
Access port
Handset plug
Getting Started with the Cisco IP Phone 7910 Series
"Safety Notices"
2-3