BIX Power BP150 Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} BIX Power BP150. BIX Power BP150 5 pages. External battery pack

Imprimer la page

Part II. Power Status: Different lighting condition of the LED display shows respective current power level of the battery:

Reminder: Do not exhaust the battery. Recharge before power is completely consumed.

LED lights on the battery display the charged level by measure the output voltage of the battery, so it is not very accurate unless each battery is

individually calibrated. Sometime, the 4th LED will never lights up even the battery is 99% charged. You can tell whether the battery is fully

charged by the LED light on the AC charger: the LED on AC charge will turn to green when the battery is fully charged.

2. Set DC Output Voltage:

notebook DC power input requirement. It is the same as the DC output voltage of your device AC power adapter or your device

input voltage.

Step 1a: Refer to the label on AC adapter for your notebook -

to check the "Output Voltage"

Step 2:

Select an output voltage, push the button to 16V or 19V, which

closes to the power input requirement of your notebook. 16V

output is compatible with a 15-17V notebook; and 19V is

compatible with 18V-20V.

3. Select right tips: Included with the battery are different connector tips and an output cable (Z6

Power Cable). One end of the output cable connects to the battery output port. The Z6 output

cable may fit a lot of laptops directly without a connector tip. If the output cable does not fit

your laptop, find the connector tip that fits your laptop first. With the connector tip not connected

to the output cable, locate the correct connector tip by fitting it into the DC Jack of your laptop. The

connector tip should fit snugly.

Note: C15, C21 ( or C22) and C24 tips look very similar, but they are for different laptops. C15 is mainly for

IBM/Lenovo laptops, C21 (or C22) is for Dell laptops and C24 is for HP Compaq laptops.

Condition of LED display

After the battery has been fully charged, set the voltage output of the battery close to your

Power Level

Less than 25% available

25-50% available

51-75% available

76-100% available

Step 1b: Refer to the label stuck on the bottom of your

notebook - to check the "power input" requirement.