Step 2
Insert the long end of the phone cord into the receiver port on the phone
body that is marked with a phone symbol.
Step 3
(Optional) Route the phone cord through the cable slot.
Step 4
Insert the other end of the phone cord into the port at the bottom of the receiver.
Step 5
(Optional) Connect the phone stand by lining up the tabs on the stand with the slots on
the phone body. Slide the bottom tabs into the lower slots on the phone body and lightly
press down on the stand. It should easily slide into the upper stand slots. Do not force.
Step 6
If you are using an external power source, insert one end of the power cord into an outlet
and insert the other end of the power cord into the power port on the phone body.
Step 7
Connect your phone to the network using one of the methods below:
•
Using an Ethernet connection
Insert one end of the Ethernet cable into the network port on the phone body marked 'SW'. Insert
the other end of the Ethernet cable into the appropriate device, such as a network switch, on your
network.
•
Using a wireless connection
You can use a Cisco WBP54G Wireless-G Bridge with the IP phone to create a wireless connection
between the phone and the network. See the WBP54G documentation on www.cisco.com for more
information. The 'Where to go from here' section contains links to the documentation area on www.
cisco.com.
Step 8
(Optional) To provide network access to a PC, connect one end of an additional Ethernet cable
(not provided) to the PC port on the back of the phone body. Connect the other end of the
Ethernet cable to the network port on your PC.
Step 9
(Optional) To install the phone on a vertical surface, use the Cisco MB100 Wall Mount bracket.
See the Cisco Small Business IP Phone SPA50X User Guide (SIP) or the Cisco Unified
Communications Manager Express for the Cisco Small Business IP Phone SPA50X documents
on www.cisco.com for more information.
0800 040 8888
v1 - 06/13
working with daisy
www.daisygroupplc.com
Imprimer la page