Cisco Nexus 7000 Series Manuel d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 18 pages. Switch chassis
Également pour Cisco Nexus 7000 Series : Manuel de référence (2 pages), Manuel d'instructions d'installation (39 pages), Référence (34 pages), Configuration (8 pages), Manuel de configuration (28 pages), Manuel de démarrage rapide (10 pages), Manuel de démarrage rapide (29 pages), Manuel d'instructions de remplacement (14 pages), Manuel d'instructions de remplacement (21 pages), Manuel d'installation (16 pages), Manuel de dépannage (10 pages)

Installation

Note

Figure 9: Configuring and Managing Hypervisor and Virtual Machines

Step 4

Configure NTP:

a) Navigate to Configuration > Software > Time Configuration.

b) Click Properties to launch the Time Configuration screen.

c) Update the Time Click Options... .

d) Select NTP Settings.

e) Click Add and type the IP address of NTP server. Repeat this step to add multiple NTP servers.

f) Click OK.

g) Select General > Start and Stop with Host.

h) Click Start button. Click OK to close the configuration screens.

Step 5

Configure network fault tolerance by using the NIC teaming feature in VMware:

a) Navigate to Configuration > Hardware > Networking.

b) Click Properties for "Standard Switch: vSwitch0," as shown in the figure below.

c) In the configuration screen vSwitch0 Properties, select the tab Network Adapters.

d) Click Add... to add the NIC that is connected to data network.

e) Follow the interactive configuration dialogs and close the configuration screens until you see two or more

NICs are added to vSwitch0, as shown in the figure below.

Note

Notice the predeployed applications listed in the inventory pane of Figure

By default, only one NIC is enabled for the Hypervisor and identified as vmnic0.

Access and Configure Hypervisor

Cisco Business Edition 7000 Installation Guide, Release 11.6