Cisco SPA302D Manuel du propriétaire - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Cisco SPA302D. Cisco SPA302D 49 pages. Mobility enhanced cordless handset
Également pour Cisco SPA302D : Manuel de l'utilisateur (38 pages), Fiche technique (7 pages), Manuel de l'utilisateur (10 pages), Manuel de démarrage rapide (2 pages)

Cisco SPA302D Manuel du propriétaire
4. Place the Handset into the charging cradle. The light on the
charging cradle appears solid green when the Handset is
charging. Charge the Handset for a minimum of 10 hours
before using the Handset for the first time to ensure that the
Handset is fully charged.
If the batteries are charged, the Handset turns on when the
batteries are inserted. If the batteries are not charged, the
Handset turns on when it is placed into the charging cradle

Note

Turning On Cordless Handset

Each Cordless Handset and Cordless Base purchased from
Intermedia will be pre-registered and configured. Additional or
replacement Cordless Handsets will need to be manually
registered (see Manual Phone Registration). The Cisco Cordless
Handsets will be shipped with the batteries pre-installed.
1. Install and configure the Cisco Cordless Base. See the Cisco
Cordless Base instructions above for more information. Cordless
Base SYSTEM
2. On the Cisco Cordless Handset, press and hold the End Call
button for 5 seconds.
3. Release the End Call
for the screen to illuminate.
4. If screen does not illuminate verify batteries are installed
correctly and charged and repeat steps 1-3.
5. Handset screen will first display date and time, followed by
steady signal strength indicator then finally the Handset phone
number.

Registering a Cordless Handset

Each Cordless Handset purchased at the time the Cordless Base
is purchased will be pre-registered. Additional or replacement
Cordless Handsets will need to be manually registered:
Install and configure the Cisco SPA232D. See the Cisco
SPA232D Quick Start Guide for more information.
and INTERNET
lights should be lit.
button and wait up to 10 seconds
17
Owner's Manual