Ricoh Plockmatic SquareBack Trimmer Manuel de l'opérateur - Page 30
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Ricoh Plockmatic SquareBack Trimmer. Ricoh Plockmatic SquareBack Trimmer 45 pages. Cip training
Imprimer la pageCIP Training Plockmatic SquareBack Trimmer
Troubleshooting
Jams
When there is either a missfeed or a fault condition in the machine, a message and a code
will be displayed on the GUI. Some codes, mainly the ones regarding jams, may be rectified by
the operator but fault codes may only be rectified by a certified service technician.
If a job is cancelled or if there is a jam, there might be an incomplete set inside the SquareBack
Trimmer. This set has to be manually removed from the system by opening and closing the
Top Cover: this will purge the set. If the set is not purged, it has to be removed by hand.
The trim unit has two sharp knives for trimming booklets: do not touch them for
any reason and at any time. If service is needed, call a technician.
To address codes other than those specified below, remove any paper in the paper path and
power off and on the system.
If the fault code persists, contact a certified service technician.
Jam codes list
Code # Area
400
Transport Module
401
Transport Module
402
Transport Module
403
Transport Module
404
Transport Module
405
Transport Module
406
Transport Module
407
Transport Module
408
Transport Module
409
Transport Module
410
Transport Module
411
Transport Module
412
Transport Module
413
Transport Module
500
Infeed
501
Infeed
502
Infeed
503
Infeed
504
Infeed
505
Infeed
506
Infeed
WARNING:
Cause
Booklet gets stuck between Q32 and Q34.
Q32 (paper path sensor) not reached in time.
Q32 (paper path sensor) covered too long.
Q32 (paper path sensor) covered after purge.
Q34 (paper path sensor) covered too long.
Q34 (paper path sensor) activated when printer is active.
Q33 (paper path sensor) not reached in time.
Q33 (paper path sensor) covered too long.
Q33 (paper path sensor) covered after purge.
Q33 and Q13 (paper path sensors) covered too long.
Q33 and Q13 (paper path sensors) covered after purge.
Q33 and Q34 (paper path sensors) covered too long.
Q33 and Q34 (paper path sensors) covered after purge.
Paper size wrong (adjust paper size in printer and/or SBT
Module).
Booklet has triggered Q26 while purging.
Q13 (paper path sensor) not reached in time.
Q13 (paper path sensor) covered too long.
Q13 (paper path sensor) covered after purge.
Q14 (paper path sensor) not reached in time.
Q14 (paper path sensor) covered too long.
Q14 (paper path sensor) covered after purge.