Ricoh Pro 8300 Series Formation Cip - Page 10

Parcourez en ligne ou téléchargez le pdf Formation Cip pour {nom_de_la_catégorie} Ricoh Pro 8300 Series. Ricoh Pro 8300 Series 12 pages.

CIP Training Pro 8300 series

Throughput

Paper path and clearing misfeeds

Procedure for removing jammed paper

Remove the jammed paper by following the procedures that are displayed on the control

panel.

When [Previous] or [Next] is displayed, press [Next] after completing a procedure.

2. When the jammed paper is removed, restore the machine to the original state.

Multiple aper misfeed locations may be indicated at the same time. When this happens, check all the areas

indicated.

If there is no misfed paper in the area you check first, see the other areas that are indicated.

If coated paper frequently becomes jammed and causes "U" to appear, contact your service representative.

If a paper misfeed occurs in Rb1 - Rb5, check whether any paper has been output on top of the paper press of the

finisher shift tray. If there is paper on top of the paper press, remove the paper, and then remove the misfed

paper from inside the finisher.

When paper cannot be transferred to the post-processing side by turning the knob D1 as instructed on the screen,

see the position of the letter in the figure and turn the knob D1 in reverse direction (clockwise) to send the paper

back to the drawer unit, and then remove the paper.

After C is displayed and the drawer unit is pulled out to remove the jammed paper, check that there is no toner

searing on the location indicated in the figure. If toner smear is left, wipe off the toner with a clean and dry

cloth.