Ricoh Pro C5100S Manuel d'utilisation - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Ricoh Pro C5100S. Ricoh Pro C5100S 36 pages. Colour controller
Également pour Ricoh Pro C5100S : Brochure & Specs (8 pages), Manuel de l'utilisateur (28 pages), Bulletin de service (15 pages)

Imprimer la page

1. Characteristics and Conditions of Paper

Print on paper under the following printing conditions:

• One-sided printing

• Print 10 sheets

• Output the paper with the printed side face down

Place the curled paper on a table or flat surface with the curl facing up.

Measure the height of the tip of the curl at each corner of the stack of paper.

Do this measurement within one minute after printing.

• If the weight of the paper is 221 g/m

Cut Edge

The condition of the cut edge of the paper affects print performance. Use paper that has a clean edge

with no burrs.

Cut paper is made by stacking many sheets together and cutting them. The cut edge of paper cut with a

sharp cutter is straight, but if the cutter is dull, then the cut edge is uneven and has thin protrusions on the

edge of the paper. These are called burrs.

1. Cut edge from a dull cutter

2. Cut edge from a sharp cutter

Burrs may cause the paper to feed at an angle, feed multiple sheets at one time, or result in misfeeds

through the machine. They may also cause paper jams in the machine and shorten the life of the fusing

unit.

If a paper jam occurs, turn over the paper in the paper tray. Changing the orientation of the burrs can

reduce the tendency for paper to jam.

Remove as much of the paper dust particles caused by the burrs as possible. These particles may reduce

the print quality.

or more, measure one sheet of paper.

CEL007