Cisco Webex 840 Manuel - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Cisco Webex 840. Cisco Webex 840 12 pages. Wireless phone
Également pour Cisco Webex 840 : Manuel de référence rapide (3 pages), Mise en place (10 pages), Manuel de dépannage (6 pages), Manuel (36 pages), Manuel de référence rapide (3 pages), Manuel de référence rapide (3 pages)
Imprimer la page
Hot Swap the Battery for Webex Wireless Phone 860 and 860S
Procedure
Step 1
To disengage the battery clip, gently use a fingernail to depress the clip towards the top of the phone.
Caution
Step 2
Use your fingernail to lift the battery gently about an eighth of an inch (a few millimeters) out of the battery
compartment.
Step 3
Release the battery clip and grab the battery with your fingers.
Step 4
Use the battery tabs and battery compartment slots as a pivot point to raise the battery edge out the battery
compartment.
Warning
Step 5
Gently withdraw the battery tabs from the battery compartment slots and lift the battery out of the battery
compartment.
Warning
Hot Swap the Battery for Webex Wireless Phone 860 and 860S
The Webex Wireless Phone 860 and 860S have a hot swap feature that allows you to continue to use your
phone while you change a low battery. During a hot swap, the internal phone battery provides minimum power
to allow the phone to remain on.
You can perform a battery hot swap under most normal operations, such as during a voice call or other activity
on an active phone screen. Active use of the phone or anything that increases the power draw during a hot
swap may, in rare situations, cause the phone to power off.
Phone Setup
4
Don't pull up on or twist the clip. Don't use a tool, such as letter opener or screwdriver, to pry the
clip open. An incorrect prying action with a tool can break the battery clip.
Don't slide the battery across the battery compartment because this action may damage the contacts.
Make sure that no part of the battery drags across the battery contacts in the phone.
Phone Setup