Cisco 10005 ESR Manuel - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Cisco 10005 ESR. Cisco 10005 ESR 33 pages.

Chapter 3

Maintaining the Cisco 10005 ESR

Shutting Down the System

Step 1

Step 2

Step 3

Warning

OL-1102-07

The following example shows the expected output after you enter the format

disk0: command:

Router# format disk0:

All sectors will be erased, proceed? [confirm]

Enter volume id (up to 30 characters): MyNewdisk

Formatting sector 1

Format device slot0 completed

Router#

The Flash memory disk is now ready for use.

Although most components in the Cisco 10005 ESR are hot-swappable, you

might have to shut down the system under certain circumstances—for example, if

you are replacing the only power module or the only PRE in a nonredundant

system.

To shut down the system:

Notify appropriate personnel that you plan to shut down the system and that a

shutdown results in loss of service. Appropriate personnel includes the regional

alarm or network monitoring center, central office personnel, and customers.

Before you shut down the router, use the copy command to save any configuration

changes to NVRAM, and also, if you wish, to a PCMCIA Flash card. (See the

Cisco 10000 Series ESR Software Configuration Guide for instructions about

using the copy command.)

Power down the system by setting the switches on all power modules to the 0 (off)

or standby position. (Your system can have one or two power modules.)

Before you work on a system that has a standby/off switch, turn off the power

by pressing the power switch to standby and unplugging the power cord.

Cisco 10005 ESR Hardware Overview and Maintenance Guide

Shutting Down the System

3-5