Cisco 1600 series Installation ou remplacement du manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Installation ou remplacement du manuel pour {nom_de_la_catégorie} Cisco 1600 series. Cisco 1600 series 10 pages. Rdiag router analog ipsec
Également pour Cisco 1600 series : Manuel de démarrage rapide (12 pages), Manuel de démarrage rapide (8 pages), Manuel d'installation du matériel (14 pages)

Removing the Router Cover

Take the following steps to remove the router cover:

Step 1

Step 2

Step 3

Step 4

Figure 1

Step 5

Step 6

Figure 2

Turn OFF the power by pressing the power switch on the rear panel to the off ( O )

position.

Disconnect all cables from the rear panel.

Place the router upside down a ﬂat, secure surface, such as a desk or table.

Using the Phillips screwdriver, remove the screw at the center of the underside of the

router, as shown in Figure 1. Put the screw in a safe place.

Removing the Screw from the Bottom of the Router

Using both hands to hold the top and bottom of the router together, turn the router over

so that it is right side up on the ﬂat surface and the rear panel is facing toward you.

Using the Phillips screwdriver, remove the two screws from the rear panel of the router,

as shown in Figure 2. Put the screws in a safe place.

Removing the Screws from the Rear Panel

Rear panel screws

Installing or Replacing the DRAM SIMM in Cisco 1600 Series Routers

Bottom of router

DO NOT INSTALL ANY WAN

MODULE WITH POWER ON

Removing the Router Cover