Cisco 1841 - 3G Bundle Router Manuel de démarrage rapide - Page 21
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco 1841 - 3G Bundle Router. Cisco 1841 - 3G Bundle Router 28 pages. Integrated services router with aim-vpn/bpii-plus integrated services router with aim-vpn/epii-plus fips 140-2 non proprietary security policy
Également pour Cisco 1841 - 3G Bundle Router : Fiche technique (11 pages), Manuel de l'utilisateur (29 pages), Manuel de l'utilisateur (9 pages)
Imprimer la page
end
Step 11 Respond to the following prompts. Select [2] to save the initial configuration.
[0] Go to the IOS command prompt without saving this config.
[1] Return back to the setup without saving this config.
[2] Save this configuration to nvram and exit.
Enter your selection [2]: 2
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
Press RETURN to get started! RETURN
The user prompt is displayed.
Router>
Step 12 Verify the initial configuration. See the "Verify the Initial Configuration" section on page 22 for verification procedures.
Initial Configuration Using Cisco CLI—Manual Configuration
This section shows how to display a command-line interface (CLI) prompt for configuration using the CLI, and it directs you
to documentation for the CLI configuration. You can use the CLI if the following messages appear at the end of the startup
sequence:
--- System Configuration Dialog ---
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to enter the initial configuration dialog? [yes/no]:
If these messages do not appear, SDM and a default configuration file were installed on the router at the factory. To use SDM
to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager" section on page 18.
For help with interface and port numbering, see the "Interface Numbering" section on page 17.
Step 1
To proceed with manual configuration using the CLI, enter no when the power-up messages end:
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to terminate autoinstall and continue with manual configuration:
Would you like to terminate autoinstall? [yes] Return
Several messages appear, ending with a line similar to the following:
Copyright (c) 1986-2004 by Cisco Systems, Inc.
Compiled < date > < time > by < person >
Step 3
Press Return to display the Router> prompt:
...
flashfs[4]: Initialization complete.
Router>
Step 4
Enter privileged EXEC mode:
Router> enable
Router#
Step 5
For configuration procedures, refer to the applicable configuration instructions in the Cisco 2800 series software
configuration documents. See the "Where to Go Next" section on page 22 for information about accessing these
documents.
21