Epson EMP-61 Manuel de référence rapide - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel de référence rapide pour {nom_de_la_catégorie} Epson EMP-61. Epson EMP-61 4 pages. Esc/vp21 command user's guide for business projectors
Également pour Epson EMP-61 : Manuel de l'utilisateur (25 pages), Manuel de l'utilisateur (25 pages), Manuel de l'utilisateur (28 pages), Manuel de l'utilisateur (28 pages), Manuel de référence rapide (4 pages)
Imprimer la page
Useful Functions
Colour mode
The following six preset types of colour mode can be selected by
selection
pressing
• Dynamic
• Living Room
Playback of images and sound can be momentarily paused and
A/V Mute
then resumed each time
Troubleshooting
Using the help function
1
Press
.
2
Select the item to view.
Tilt
on the remote control or press
and
on the projector's control panel to
select an item.
Checking the indicators
These indicators alert you to problems with projector operation. The following tables show what the
indicators mean and how to remedy problems that they indicate.
Refer to "Problems Solving" in the User's Guide for further details.
If all indicators are switched off, check that the power cable is connected correctly and that power is
being supplied normally.
Normal
Status
Problem and remedy
Standby condition
Power
Orange
The power cable should only
be disconnected in this
condition.
Projection starts when you
press
Warm-up in progress
Power
Green
After warm-up finishes,
projection starts when an
image signal is input.
Projection in progress
Power
Green
Cool-down in progress
Power
Orange
The projector changes to
standby (indicator lights
orange) after about 20
seconds.
Printed in China
04.XX-.XA(G04)
405128100E
on the remote control.
• Presentation
• sRGB
Lit
Flashing
Off
.
• Theatre
• Blackboard
on the remote control is pressed.
3
Accept the selection.
Press the to confirm the selection of a menu
item.
4
The help contents will then be displayed.
The help menu is cleared when
Problem/Warning
Status
High temperature inside projector (overheating)
Power
Red
The lamp will turn off automatically and projection
Red
will stop. Wait for about 5 minutes. Then press
turn the projector back on.
Power
Lamp problem
Red
Red
Remove the lamp and check if it is broken. If the
lamp is not broken, reinsert it. If the lamp is broken
replace it with a new lamp, or contact your local
dealer for further advice.
Power
Internal problem
Red
Red
Stop using the projector and send it for service.
Red
Power
Red
Something is wrong with the fan or the sensor.
Stop using the projector and send it for service.
Red
Power
Red
High-speed cooling in progress. If the temperature
rises too high again, projection will stop automatically.
Orange
Check that the air filter and air exhaust vent are clear,
and that the internal room temperature is not too high.
It is time to replace the lamp.
Power
Orange
Replace the lamp with a new one as soon as
possible.
If you continue to use the old lamp, the possibility that
the lamp may break will increase.
*1 Contact your dealer for a spare lamp.
*2 For repairs, contact your dealer or the nearest address provided
in the "International Warranty Conditions" section in the Safety
Instructions/World-Wide Warranty Terms booklet.
User's Guide
"Selecting the Projection
Quality (Colour Mode
Selection)"
User's Guide
"A/V Mute"
User's Guide
"Troubleshooting"
Lit
Problem and remedy
*1
is pressed.
Flashing
Off
to
*2
*2