Cisco 2525 Manuel de configuration

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Cisco 2525. Cisco 2525 23 pages. Troubleshooting guide
Également pour Cisco 2525 : Manuel de configuration (23 pages), Vue d'ensemble (10 pages), Préparation de l'installation (19 pages), Manuel de dépannage (4 pages)

C H A P T E R

Conﬁguring the Cisco 2524 and

Cisco 2525 Routers

This chapter describes how to conﬁgure the Cisco 2524 and Cisco 2525 routers and

contains the following sections:

•

Booting the Router for the First Time

•

Conﬁguring the Router

•

Specifying the Boot Method

•

Checking the Conﬁguration Settings

•

Getting More Information

This chapter provides just enough information to get the router up and running. For

Cisco IOS Release 11.0 and earlier releases, refer to the Router Products Conﬁguration

Guide for additional conﬁguration information. For Cisco IOS Release 11.1 and later

releases, refer to the Conﬁguration Fundamentals Conﬁguration Guide.

Booting the Router for the First Time

Each time you power on the router, it goes through the following boot sequence:

The router goes through power-on self-test diagnostics to verify basic operation of the

CPU, memory, and interfaces.

The system bootstrap software (boot image) executes and searches for a valid Cisco IOS

image (router operating system software). The source of the Cisco IOS image (Flash

memory or a Trivial File Transfer Protocol [TFTP] server) is determined by the

conﬁguration register setting. The factory-default setting for the conﬁguration register

is 0x2102, which indicates that the router should attempt to load a Cisco IOS image

from Flash memory.

Configuring the Cisco 2524 and Cisco 2525 Routers 4-1