Cisco 2811 Series Opérations - Page 17

Parcourez en ligne ou téléchargez le pdf Opérations pour {nom_de_la_catégorie} Cisco 2811 Series. Cisco 2811 Series 31 pages. 2800 series integrated services routers
Également pour Cisco 2811 Series : Fiche technique (20 pages), Opérations (31 pages), Installation et mise à niveau (14 pages), Manuel de démarrage rapide (47 pages)

Imprimer la page

Figure 11 – 2811 Tamper Evident Label Placement on the Opacity Shield

For Cisco 2821:

1. Clean the cover of any grease, dirt, or oil before applying the tamper evidence

labels. Alcohol-based cleaning pads are recommended for this purpose. The

temperature of the router should be above 10 C.

2. The tamper evidence label should be placed so that one half of the label covers

the front panel and the other half covers the enclosure.

3. The tamper evidence label should be placed over the CF card in the slot so that

any attempt to remove the card will show sign of tampering.

4. The tamper evidence label should be placed so that the one half of the label

covers the enclosure and the other half covers the port adapter slot.

5. The tamper evidence label should be placed so that the one half of the label

covers the enclosure and the other half covers the rear panel.

6. Place tamper evident labels on the opacity shield as shown in Figure 14.

7. The labels completely cure within five minutes.

Figures 12, 13 and 14 show the additional tamper evidence label placements for the 2821.

This document may be freely reproduced and distributed whole and intact including this Copyright Notice.