Cisco 3600 Series Note de configuration - Page 12

Parcourez en ligne ou téléchargez le pdf Note de configuration pour {nom_de_la_catégorie} Cisco 3600 Series. Cisco 3600 Series 18 pages. Memory upgrade
Également pour Cisco 3600 Series : Aperçu du produit (10 pages), Instructions de mise à niveau (30 pages), Manuel du propriétaire (17 pages), Note d'application (41 pages), Manuel de configuration (36 pages), Manuel de l'utilisateur (25 pages), Annexe (15 pages), Manuel de l'utilisateur (7 pages), Manuel (5 pages), Note de configuration (23 pages), Note de configuration (25 pages)

Imprimer la page
Cisco 3600 Series Note de configuration
Wall-Mounting the Router
Wall-Mounting the Router
This section explains how to mount a Cisco 3620 or Cisco 3640 router on a wall. If you have
questions or need help with the wall-mounting procedure, refer to the section "Obtaining Service
and Support" later in this document.
If you are planning to wall-mount your router, do so before making network and power connections.
If you need to install network modules or WAN interface cards, you can do so either before or after
mounting the router, whenever you have better access to the rear of the router.
Note
structure.
Required Tools and Equipment
You need the following tools and equipment to install a Cisco 3600 series router on a wall:
•
•
•
•
•
•
Cisco Systems does not supply the board or screws.
Each router is shipped with one set of brackets. Brackets for 19-inch racks are shipped unless you
specify 23-inch or 24-inch brackets at the time of your order. The Cisco 3620 router uses 19-inch
rack brackets to mount on a wall, and the Cisco 3640 router uses 23-inch or 24-inch rack brackets
to mount on a wall. Figure 23 shows the wall-mount brackets.
Figure 23
Bracket for wall-mounting
Cisco 3620.
12 Cisco 3600 Series Rack-Mount and Wall-Mount Configuration Note
When choosing a wall on which to mount the router, consider cable limitations as well as wall
Number 2 Phillips screwdriver
Small flat-blade screwdriver (Cisco 3620 router only)
Plywood board at least 24 inches wide, 19 inches high, and 1/2 inch thick (60 x 50 x 1.3 cm)
Eight M3.5 or #6 x 1/2-inch flat-head wood screws
Four wood screws, at least 3/16-inch x 2 1/2-inch, to mount the plywood to the wall
ESD-preventive wrist strap
Wall-Mount Brackets
Use with 23-inch rack
Use with 24-inch rack
Bracket for wall-mounting
Cisco 3640