Cisco 3620 Manuel de démarrage rapide - Page 22
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco 3620. Cisco 3620 37 pages. Rack-mount and wall-mount
Également pour Cisco 3620 : Manuel du propriétaire (17 pages), Note de configuration (18 pages)
Imprimer la page
5
Power Up the Router
Checklist for Power-Up
You are ready to power up the Cisco router if the following steps are completed:
• Chassis is securely mounted and grounded.
• Power and interface cables are connected.
• Your PC terminal emulation program is configured for 9600 baud, 8 data bits, 1 stop bit, and no parity.
• You have selected passwords for access control.
• You have determined the IP addresses for the Ethernet and serial interfaces.
Front Panel Indicators
The following indicator LEDs provide power, activity, and status information:
• Power (green)—Lit when power is on
• Sys/RPS (green):
–
Rapid blinking (200 ms)—System is booting
Slow blinking (1 s)—Redundant power supply (RPS) failure
–
Continuous on—System OK
–
• Activity (green)—Blinks during system activity, such as interrupts and packet transfers
Power-Up Procedure
Perform this procedure to power up your Cisco router and verify that it goes through its initialization and self-test. When the
procedure is finished, the Cisco router is ready to configure.
To view the boot sequence through a terminal session, you must have a console connection to the Cisco router before
Note
it powers up.
Step 1
Make sure that your PC is powered up and connected as described in the "Checklist for Power-Up" section.
Step 2
Move the power switch to the ON position.
The green LED next to the auxiliary port comes on and the fan operates. If this does not happen, see the power-up
procedure in the Cisco 3600 Series Routers Hardware Installation Guide.
Messages begin to appear in your terminal emulation program window.
Do not press any keys on the keyboard until the messages stop. Any keys pressed during this time are interpreted
Caution
as the first command typed when the messages stop, which might cause the router to power off and start over. It
takes a few minutes for the messages to stop.
22