Cisco 3640 Series Manuel de démarrage rapide - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco 3640 Series. Cisco 3640 Series 37 pages. Rack-mount and wall-mount
Également pour Cisco 3640 Series : Manuel d'installation (10 pages), Manuel du propriétaire (17 pages), Manuel de l'utilisateur (26 pages), Manuel (10 pages), Note de configuration (18 pages)

Figure 21

SDM Launch Page

Tip

If the SDM Launch page does not appear when you enter the URL https://10.10.10.1/flash/sdm.shtml, test the

connection between the PC and the router by doing the following:

a. Check that the POWER LED on the router is on, and that the ACTIVITY LED is on, indicating an active Ethernet

connection between the router and the PC. If the ACTIVITY LED is not on, verify that you are using a crossover cable

to connect the PC to the router.

b. If the Launch page still does not appear, verify that the web browser's "work ofﬂine" option is disabled. In Internet

Explorer, click the File menu, and verify that the "work ofﬂine" option is unchecked. In Netscape, the default selection

in the File menu is set to "work online."

c. If the Launch page still does not appear, verify that the ﬁle sdm.tar is loaded into the router's Flash memory. Open a

Telnet session to 10.10.10.1, entering the username sdm and the password sdm. Enter the command show ﬂash to verify

that sdm.tar is loaded in Flash memory.

d. If the web page still does not appear, verify that the PC is conﬁgured with a static IP address.

Step 5

A window appears with information about the web browser and its settings. This window also informs you that SDM

will open in another window. Close this window and wait for the SDM Startup Wizard page to appear.

Step 6

When the SDM Startup wizard appears, click Next to begin. Use the wizard to give the router a hostname, to assign a

interface 0/0. You can also configure the router as a Dynamic Host Configuration Protocol (DHCP) server, identify

Domain Name System (DNS) and Windows Internet Naming Service (WINS) servers, and make security settings.

Tip

Be sure to write down the enable secret password. It is not revealed in the summary window and cannot be recovered.

Step 7

When the Summary window appears, write down the LAN IP address, hostname, login username, and user password

that you entered, and click Finish. (You will need this information to reconnect to the router and use SDM to perform

additional configuration.)

Step 8

Assign a new IP address to the PC's Ethernet interface; place it on the same subnet as the router's FastEthernet 0/0 port,

which you assigned in Step 6 above. (See Figure 22.) If you configured a DHCP server on the router, configure the PC

to obtain an IP address automatically. The IP addresses in Figure 22 are examples only.