Cisco 4000 Series Manuel de mise à jour - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de mise à jour pour {nom_de_la_catégorie} Cisco 4000 Series. Cisco 4000 Series 24 pages. Upgrading memory
Également pour Cisco 4000 Series : Manuel (18 pages), Préparation de l'installation (11 pages), Manuel d'installation (18 pages), Manuel de remplacement (16 pages)

Imprimer la page

Step 7

Step 8

Proceed to the next section, "Removing Network Processor Modules."

Removing the Component Tray from a Chassis without a Safety Latch

Take the following steps to remove the component tray from a chassis without a safety latch:

Step 1

Step 2

Step 3

Step 4

Warning

the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that

services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of

the circuit breaker in the OFF position.

Step 5

Figure 4

Chassis shell

Support the component tray with one hand, push down on the safety latch tab, and pull the

component tray out the rest of the way.

Set the component tray on your work surface.

Turn OFF the system power.

Attach your ESD-preventive wrist strap.

Remove all network and power cables.

If you have a DC-powered router, take these steps to remove the power cables:

Before performing any of the following procedures, ensure that power is removed from

•

Use a screwdriver to loosen the captive installation screws on the terminal block cover.

•

Lift and remove the terminal block cover.

•

Use a screwdriver to remove the three power leads from the terminal block in the

following order: negative, positive, then ground.

Loosen the nonremovable chassis release screw on the rear panel of the chassis. (See

Figure 4.)

Component Tray Removal for Chassis without a Safety Latch

AUX

Rear of the chassis

Support the component

Upgrading Cisco 4500, Cisco 4500-M, Cisco 4700, and Cisco 4700-M Memory

Accessing the Internal Components of the Router

Chassis release

screw

CONSOLE

tray with your hand

INPUT 100-240VAC

50/60HZ 3.0-1.5 AMPS

Handle