Cisco 4000-M series Manuel d'installation - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco 4000-M series. Cisco 4000-M series 18 pages. Replacing the power supply
Également pour Cisco 4000-M series : Manuel de remplacement (16 pages)
Imprimer la page
If you have an older version of the chassis, use the first of the following procedures to install the telco
rack-mount or wall-mount brackets. If you have a new version of the chassis, use the second
procedure to install the telco rack-mount or wall-mount brackets. After installing the brackets, use
the appropriate procedure to install the chassis in a telco rack or on a wall.
Installing Telco Rack-Mount or Wall-Mount Brackets into an Old Version of the Chassis
Take the following steps to install telco rack-mount or wall-mount brackets into the old version of
the chassis:
Step 1
Step 2
Step 3
Note
screw locations apply only to the wall-mount procedures.
Figure 14
19 x 19 x 1/2" or larger plywood
Remove the component tray from the system. Refer to the procedure described in the
section, "Preparing the Chassis for Rack-Mounting or Wall-Mounting."
Insert one rack-mount bracket into the slot on each side of the shell, sliding the bracket
straight into the shell's inner two-inch brackets.
Fasten the bracket to the shell on each side of the chassis shell with one M3 machine screw
(as shown in Figure 14).
Figure 14 shows screw locations for both telco rack-mounting and wall-mounting. The wood
Screw Locations for Telco Rack-Mount or Wall-Mount Brackets – Old Version of the
Chassis
board (if wall-mounted)
Overview of Telco Rack-Mounting and Wall-Mounting
Wood screws
Telco rack-mount
or wall-mount bracket
Cisco 4000 Series Rack-Mount and Wall-Mount Installation
Chassis shell
M3 machine
screw
Front of the chassis
13