Cisco 4430 Introduction - Page 6

Parcourez en ligne ou téléchargez le pdf Introduction pour {nom_de_la_catégorie} Cisco 4430. Cisco 4430 13 pages. Content router 4430

System Hardware Features

Cables and Connectors

Cisco Content Router 4430 Hardware Installation Guide

1-6

Table 1-3

LEDs (continued)

Indicator

Status 0 1 2 3 LEDs Green

This section describes the cables and connectors that connect your

Content Router 4430 to a terminal and to the external network.

The Content Router 4430 comes with a console cable kit that includes the

following cable and adapters:

One RJ-45 to RJ-45 rollover cable

•

Two RJ-45 to DB-9 adapters

•

Use the rollover cable to connect the Content Router 4430 console port to the

COM port of an ASCII terminal or a PC running terminal emulation software. The

console port on the Content Router 4430 is configured as data terminal equipment

(DTE) and uses an RJ-45 connector.

By attaching an RJ-45 to DB-9 adapter to the rollover cable, you create an RJ-45

to DB-9 null modem cable.

You can identify a rollover cable by comparing the two modular ends of the cable,

as shown in Figure 1-3. Holding the cable ends in your hands side by side with the

tab at the back, the wire connected to the pin on the outside of the left connector

(pin 1) should be the same color as the pin on the outside of the right connector

(pin 8).

Chapter 1

Color

State

Description

Steady

In a steady display, the state of each

LED is constant. (See Table 3-1 for the

meanings of steady-state LED

variations.)

Rolling Reboot has begun.

In a rolling display, the four LEDs give

the appearance of a light that

repeatedly moves from left to right.

Introducing the Content Router 4430

78-12541-01