Cisco 4500-M Manuel d'installation - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco 4500-M. Cisco 4500-M 18 pages. Upgrading memory
Également pour Cisco 4500-M : Manuel de remplacement (16 pages), Manuel de mise à jour (24 pages)

Imprimer la page

The chassis should be wall-mounted with the front and rear of the chassis perpendicular to

Note

the ﬂoor and at eye level, so you can read the front and rear LEDs. All four mounting screws must

be anchored to solid wood.

Step 3

Lay the chassis on top of a plywood board (19 x 19 x 1/2 inch minimum, not supplied).

Using the chassis as a pattern, mark or drill the wall-mount screw locations on the board.

To make inserting the screws easier, drill the screw locations before you mount the chassis.

To safely accommodate variations in interior wall construction, locate the wall studs (2 x 4"

Step 4

boards inside a building's walls, commonly spaced 16 inches apart) and attach the plywood

board securely to the wall, nailing the board to the studs.

Step 5

Start the two screws that will be used to fasten the bottom bracket in their places on the

bottom of the board, leaving at least 1/4 inch of each screw exposed.

Insert the lower bracket into the two wood screws you just placed on the piece of plywood

Step 6

(see Figure 14 or Figure 15). While continuing to support the chassis shell, insert one wood

screw through the top wall-mount bracket to hold the chassis in place. Follow this by

inserting the second wood screw into the top wall-mount bracket.

Step 7

Tighten all wood screws.

Step 8

Reinsert the component tray into the shell.

Step 9

Push on the back of the tray while at the same time pressing on the chassis release screw

(shown in Figure 2 and Figure 3) with the thumb of your right hand.

Retighten the chassis release screw.

Step 10

This completes the wall-mount procedure.

Mounting the Chassis Shell on a Wall

Cisco 4000 Series Rack-Mount and Wall-Mount Installation