Cisco 6000 series Manuel d'installation du matériel - Page 30
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco 6000 series. Cisco 6000 series 30 pages. Network convergence system
Imprimer la page
Installing the Front Exterior Cosmetics
Attach the left and right vertical cable troughs to the front of the chassis
Step 2
cable troughs are inverted from each other. For each vertical cable trough:
a.
Align the guide pins on the rear of the vertical cable trough with the positioning holes on the front
of the chassis
b.
Loosely insert eight pan-head screws, and then use the screwdriver to tighten them clockwise to
attach the vertical cable troughs firmly to the front of chassis. You might need to use a ladder to
reach the upper screws.
Note
Figure 3-4
1 Vertical cable trough
2 Guide pin
Attach the front cable management brackets
Step 3
Attach the upper horizontal bracket (above the LC cage) by inserting and tightening four pan-head
a.
screws.
Attach the lower horizontal brackets (below the LC cage) by inserting and tightening five pan-head
b.
screws.
Attach the front door alignment bracket to the chassis above the craft display panel by inserting and
Step 4
tightening two pan-head screws along with tightening the captive screw
Attach the door hinge attachments, three left and three right, using two pan-head screws each
Step 5
(Figure
Cisco Network Convergence System 6000 Series Routers Hardware Installation Guide
3-6
(Figure
3-4).
We recommend that you use two people to attach the vertical cable troughs; one person to hold
the vertical cable troughs in place while the other person inserts and tightens the screws.
Vertical Trough with Guide Pins
3-5).
Chapter 3
(Figure
3-3).
Installing the Exterior Cosmetics
(Figure
3-3). The two vertical
1
2
(Figure
3-3).
OL-29234-02