C.T.M. HS-559 Manuel d'entretien - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} C.T.M. HS-559. C.T.M. HS-559 14 pages.

Service Manual‐ CTM HS‐559

4‐5

Rear Wheel, Motor, Transaxle.

Tool requirement,

5mm hex‐key wrench

17mm socket wrench

12mm offset wrench

Instruction for disassembly

G. Please turn off the scooter and remove the key. Make sure the ND lever is in D position before this job.

H. Leak some air from wheel before you disassemble the wheel. (refer to 4‐4)

I. Use a ratchet and socket to remove the front wheel screw from the center hub of the wheel.

J. Separate the tire from the rim.

K. Replace the parts (inner tube or outer tube) as the demand.

L. Install the drive wheel nut into the center hub and verify the key is lined up with axle and wheel, and

then tighten to secure it in place. The torque 300±30kgf‐cm.

Inspection points

When assembling, please use the torque wrench to make sure the tightening torque as the drawing.

Range of tire pressure is around 35~40 psi.