Cisco NCS 5500 Series Manuel - Page 21

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Cisco NCS 5500 Series. Cisco NCS 5500 Series 25 pages. Connect router to the network
Également pour Cisco NCS 5500 Series : Manuel de configuration (19 pages), Manuel de connexion (24 pages)

Imprimer la page

Connect Router to the Network

Step 4

Grasp the CFP2 module between your thumb and index finger and carefully remove it from the port.

Step 5

Place the removed CFP2 module on an antistatic mat, or immediately place it in a static shielding bag if you plan to return

it to the factory.

Connect Interface Ports

You can connect optical interface ports on line cards with other devices for network connectivity.

Connect a Fiber-Optic Port to the Network

Depending on the line card model that you are using, you can use either QSFP+ or QSFP28 transceivers.

Some transceivers work with fiber-optic cables that you attach to the transceivers and other transceivers work

with pre-attached copper cables. When installing fiber-optic cables for a port, you must install SFP transceivers

for 1-Gigabit optical ports or install SFP+ transceivers for 10-Gigabit optical ports or QSFP+ transceivers for

100-Gigabit ports before installing the fiber-optic cable in the transceivers.

Caution

Removing and installing a transceiver can shorten its useful life. Do not remove and insert transceivers any

more than is absolutely necessary. We recommended that you disconnect cables before installing or removing

transceivers to prevent damage to the cable or transceiver.

Disconnect Optical Ports from the Network

When you need to remove fiber-optic transceivers, you must first remove the fiber-optic cables from the

transceiver before you remove the transceiver from the port.

Connecting a Cable to the GNSS Antenna Interface

Step 1

Connect one end of a shielded coaxial cable to the GNSS RF IN port.

Step 2

Connect the other end of the shielded coaxial cable to the GNSS antenna after the primary protector.

The GNSS RF In port should have a primary protector installed to meet the Local Safety guidelines.

Note

Connect Interface Ports

Connect Router to the Network