CAB 5946091 Manuel de l'opérateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} CAB 5946091. CAB 5946091 10 pages. External unwinder eu4 for thermal transfer printer a3/a4/m4

Imprimer la page

1. Product Description

Retaining Rolls with 1.56 in ( 40 mm) Cardboard Core on the Winding Axle

NOTICE !

Before mounting the winding axle read this chapter and "Insertion of the

prepared Winding Axle" and attend on the running of the media in dependence

to inside and outside wound label rolls.

NOTICE !

For rolls with 1.56 in ( 40 mm) cardboard core you have to dismount the

winding adapters from the flanges. The spring has to be mounted on the

winding axle ( vide "Preparing the Winding Axle and the Flanges").

Fig. 5 Mounting the Winding Axle

NOTICE !

Align the second flange (3b) to the first flange (3a)!

If the material roll is smaller than the spring on the axle, pay attention that the

spring on the axle is guided in the groove of the flange, if necessary align

flange (3a) to flange (3b)!

Now you can continue with the "Insertion of the prepared Winding Axle".

Slide the flange (3a) on the winding axle (2) so that the attachment of the

flange points to the outside.

Align the flange (3a) so that the screw (10) grasps into the groove (11) of

the winding axle (2). Tighten the screw (10) in the flange.

Slide the material roll (12) onto the axle until it touches the flange slightly.

Push the second flange (3b) with the attachment outside onto the axle

until it touches the material roll.

Tighten the knurled screw (13) in the flange (3b).

3b 13