Cisco SG 300-10P Manuel de démarrage rapide - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco SG 300-10P. Cisco SG 300-10P 18 pages. Managed switches
Également pour Cisco SG 300-10P : Manuel de démarrage rapide (17 pages), Fiche technique (14 pages), Spécifications (2 pages), Manuel d'installation rapide (10 pages), Manuel de démarrage rapide (17 pages), Manuel de démarrage rapide (17 pages)

There is a wall-mount kit packed with your switch. The dimensions for the

mount kit are as follows:

1 8 mm/0.4 in

Mount the managed switch to the wall by drilling two pilot holes

3.7 inches (95 mm) apart, attaching the provided anchors and screws to

the wall, then sliding the switch into position on the screws.

The switch should have a minimum of 5 inches (130 mm) of clearance on all

sides.

Insecure mounting may damage the device or cause injury.

ARNING

Cisco is not responsible for damages incurred by insecure wall-

mounting.

Connecting Network Devices

To connect the switch to the network:

Connect the Ethernet cable to the Ethernet port of a computer,

TEP

printer, network storage, or other network device.

Connect the other end of the network Ethernet cable to one of the

TEP

numbered managed switch Ethernet ports.

The Ethernet port light turns green when the connection is active.

Refer to

details about the different ports and LEDs on each switch.

Cisco 300 Series Managed Switches

2 22.2 mm/0.9 in 3 6.8 mm/0.3 in 4 17.6 mm/0.7 in

Features of the Cisco 300 Series Managed Switch

for