CAB ER4/210 Manuel de l'opérateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} CAB ER4/210. CAB ER4/210 14 pages. External rewinder
Également pour CAB ER4/210 : Manuel de l'opérateur (14 pages)
Imprimer la page
5
Operation
5.1
Rewinding Directly onto the Rewind Axle
i
Notice!
First remove the spring (2) from the rewind axle!
Warning!
!
Risk of injury by rotating engine parts.
When switching on the Rewinder starts immediately and winds to the material is tightened.
1
2
3
6
7
5
Figure 7
Direct rewinding
5
3
4
4
8
9
1. Loosen the screws (1) and remove the spring (2).
i
Notice!
Consider the required direction of rewinding :
- The broken line is valid for inside wound labels.
- The full line is valid for outside wound labels.
2. Feed the label strip over the guide axle (9) and under the
roller (8) to the rewind axle (7)
3. Attach the label strip appropriately to the rewind axle by
sliding the clamp (5) over the label strip with the clamp set
in the groove of the rewind axle (7).
4. Slide the clamp (5) as far as possible towards the disc (6).
5. Slide the plate (4) onto the rewind axle so that it slightly
touches the label strip. The label strip must be able to
move between the disc and the plate.
6. Tighten the knurled screw (3) on the plate.
7. Switch on the rewinder on the power switch.
.
11