Cisco 500 Series Guide de démarrage rapide - Page 10

Parcourez en ligne ou téléchargez le pdf Guide de démarrage rapide pour {nom_de_la_catégorie} Cisco 500 Series. Cisco 500 Series 13 pages. Stackable managed switches
Également pour Cisco 500 Series : Manuel d'information sur la sécurité (42 pages), Manuel (4 pages), Manuel de démarrage rapide (21 pages), Fiche technique (5 pages), Manuel de l'utilisateur (4 pages), Manuel de l'utilisateur (6 pages), Manuel de l'utilisateur (46 pages), Manuel (40 pages), Manuel d'administration (48 pages), Manuel (24 pages), Dépannage et maintenance (15 pages), Manuel de référence rapide (7 pages), Manuel de démarrage rapide (25 pages)

Because the factory default IP address configuration is DHCP, make sure

that your DHCP server is running and can be reached. You may need to

disconnect and reconnect the devices for them to discover their new IP

addresses from the DHCP server. You can then query the DHCP server for

the new IP address. See

Configuration" on page 7

address.

If the wireless access points do not receive a DHCP response (there is no

DHCP server on your network) after 60 seconds, the access points will

fallback to the following default static IP address: 192. 1 68. 1 .245 and a

default mask of 255.255.255.0. To reach that IP address, be sure that your

computer is on the 192. 1 68. 1 .xxx network.

Rebooting the Devices or Returning them

to their Factory Default Settings

To reboot your device:

• Unplug your Ethernet connection for three seconds and plug it back in.

• With the power on, press the Reset button with an opened paperclip for

less than three seconds, or until the lights go off.

–

When all the lights go off, release the Reset button.

–

Release the Reset button as soon as the lights go off, or you will

restore the device to factory default settings and lose your

configurations.

To reset the device to factory default settings:

• To restore the device to the factory default settings, with the power on,

press-and-hold the Reset button with an opened paperclip for more

than 10 seconds.

–

All of the lights will go off.

–

Release the Reset button when power light turns on.

Step 2

"Getting Started with the

for more information on how to find the DHCP

Cisco Small Business WAP500 Series Wireless Access Point