Cisco 7200 VXR Series Manuel de démarrage rapide - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco 7200 VXR Series. Cisco 7200 VXR Series 48 pages. Preparing for installation
Également pour Cisco 7200 VXR Series : Fiche technique (12 pages), Manuel (14 pages)
Imprimer la page
2
Prepare for Installation
Warning
Only trained and qualified personnel should install, replace, or service this equipment. Statement 1030
Warning
Read the installation instructions before you connect the system to its power source. Statement 10
Warning
This unit is intended for installation in restricted access areas. A restricted access area is where access can only
be gained by service personnel through the use of a special tool, lock and key, or other means of security, and is
controlled by the authority responsible for the location. Statement 37
Before beginning this router installation read the
document including the section "Site Preparation and Safety Information."
Site Preparation and Unpacking
• Lift the router safely out of the packing container.
• Ensure the power service at the site is suitable for the router you are installing.
• Check the packing slip to ensure that all the proper components are present.
• Locate and have accessible the Site Log for recording information about this installation.
Tools and Parts
Part
• Grounding lug and wires:
–
A grounding lug with two number-10 screw holes with a 0.63-inch
(16.002-mm) spacing between them
A wire receptacle large enough to accept a 6-AWG multistrand,
–
copper wire
–
Two Phillips machine screws with locking washers—M5 (metric),
0.031-inch (.08-mm) pitch, 0.315-inch (8-mm) length
A crimping tool to fit the grounding lug wire receptacle
–
One grounding wire—6-AWG, 0.162-inch (4.115-mm) diameter,
–
with approximately 0.108-inch (2.743-mm) insulation, for a total
wire diameter of approximately 0.27 inches (6.858 mm). The wire
length depends on your router location and site environment.
• The rack-mount and cable-management kit:
Two rack-mount brackets and two cable-management brackets
–
Four M4 x 8-mm Phillips flathead screws
–
Six 10-32 x 3/8-inch slotted binderhead screws
–
6
Regulatory Safety and Compliance Information for Cisco 7200 Series Routers
Part
• Power cord
• Appropriate cables to connect the router to
the network and console terminal
• Level
• Data service unit (DSU) to connect each
serial port to an external network
• Tape measure
• One serial port adapter cable for each serial
port to connect the port with the remote
device or network Ethernet transceiver
• Number 2 Phillips screwdriver
• 3/16-inch flat-blade screwdriver
• Wire stripper
• ESD-preventative wrist strap