Argent C10SF1001 Instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Argent C10SF1001. Argent C10SF1001 2 pages. Centra floor mounted
Imprimer la pageINSPECT THE FURNITURE TO
ENSURE NO DAMAGE HAS
OCCURRED DURING TRANSIT.
IF DAMAGE HAS OCCURRED,
OR VISIBLE DEFECTS EXIST,
D O N O T P R O C E E D W I T H
INSTALLATION AND ADVISE
ARGENT IMMEDIATELY.
PRIOR TO INSTALLATION
Argent recommends a qualified
trade person fit your vanity. Ensure
your furniture is installed to relevant
building codes and Australian
standards.
Please note, Argent will not be liable
for the cost of installation or removal
of the furniture and the warranty will
be voided if damage occurred during
or after installation.
To establish the correct height for
the basin assemble as per steps
1-4
shown in drawings and mark
fixing holes.
Fit wall hung basin at required height
to secure stud or frame landing,
ensure level. Fit plumbing.
(1)
Remove
any shelves, doors
and draws of vanity and set aside
carefully. Carefully turn vanity on
(2)
to it's back. Attach
vanity feet
provided. Secure all four feet with
screws provided. Line feet up with
(3)
edge of body box or just inside
as shown.
3
2
2
1
1
4
3
C
4
Ensure all gaps are equal & fit is correct
by adjusting all doors & draws.
MEASURE & MARK
Hold vanity at an angle as you carefully push the
vanity in towards and up and against the wall.
If ground is uneven under vanity adjust
to ensure vanity is level.
FIT OFF & ADJUST
C
(5)
Position
internal draw box, using locating dowel.
Replace any shelves, doors and adjust to ensure all are
square with the installed vanity.
5
(4)
all four feet
Door Adjustment
Vertical Adjustment
Forward & Back
Adjustment
Feet Adjustment
Vertical Adjustment
IMP ORTA NT:
INSPECT THE FURNITURE TO
ENSURE NO DAMAGE HAS
OCCURRED DURING TRANSIT.
IF DAMAGE HAS OCCURRED, OR
VISIBLE DEFECTS EXIST, DO NOT
PROCEED WITH INSTALLATION
AND ADVISE ARGENT
IMMEDIATELY.