Cisco AIR-SAP3702I-E-K9 Manuel de démarrage - Page 15

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco AIR-SAP3702I-E-K9. Cisco AIR-SAP3702I-E-K9 45 pages.

Configure the access point if required. Use the controller CLI, controller GUI, or Cisco Prime

Step 3

Infrastructure to customize the access-point-specific 802.11ac network settings.

If the pre-installation configuration is successful, the Status LED is green indicating normal

Step 4

operation. Disconnect the access point and mount it at the location at which you intend to

deploy it on the wireless network.

If your access point does not indicate normal operation, turn it off and repeat the

Step 5

pre-installation configuration.

When you are installing a Layer 3 access point on a different subnet than the Cisco

Note

wireless LAN controller, be sure that a DHCP server is reachable from the subnet on

which you will be installing the access point, and that the subnet has a route back to

the Cisco wireless LAN controller. Also be sure that the route back to the Cisco

wireless LAN controller has destination UDP ports 5246 and 5247 open for CAPWAP

communications. Ensure that the route back to the primary, secondary, and tertiary

wireless LAN controller allows IP packet fragments. Finally, be sure that if address

translation is used, that the access point and the Cisco wireless LAN controller have

a static 1-to-1 NAT to an outside address. (Port Address Translation is not

supported.)

Mounting the Access Point

Cisco Aironet 3702 series access points can be mounted in several configurations, including on a

suspended ceiling, on a hard ceiling or wall, on an electrical or network box, and above a suspended

ceiling. Click this URL to browse to complete access point mounting instructions:

http://www.cisco.com/en/US/docs/wireless/access_point/mounting/guide/apmount.html

After you have mounted the access point, follow these steps to deploy it on the wireless network:

Connect and power up the access point.

Step 1