DigitaLinx DL-HDE100-H2 Manuel du propriétaire - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DigitaLinx DL-HDE100-H2. DigitaLinx DL-HDE100-H2 15 pages.

Connecting IR Control

The DL-HDE100-H2 is capable of transmitting bi-directional IR signals through the HDBaseT circuit. The DL-

HDE100-H2 comes with 1 IR receiver (eye) and 1 IR emitter (flasher) so you can control devices from either end

of the extender circuit.

Passing IR Signals:

The

to any of the electronics, the extenders should be powered off while inserting or removing any

IR components. Inserting an IR transmitter into the IR IN port may damage the IR circuit for that

extender.

Attach the IR emitter to the IR receiver of the source device, insert the TS 3.5 mm plug of the emitter to the IR

OUT port of the DL-HDE100-H2 transmitter. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port

of the DL-HDE100-H2 receiver. Point the source device IR remote at the display location where the IR receiver is

located, IR signals will now travel through HDBaseT to the DL-HDE100-H2 transmitter side where the IR emitter

is attached to the source device.

Attach the IR emitter to the IR receiver of the display device, insert the TS 3.5 mm plug of the emitter to the IR

OUT port of the DL-HDE100-H2 receiver. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port of

the DL-HDE100-H2 transmitter. Point the source device IR remote at the source device location where the IR

receiver is located, IR signals will now travel through HDBaseT to the DL-HDE100-H2 receiver side where the IR

emitter is attached to the display device.

To pass 3rd party IR system signals through the DL-HDE100-H2, such as a control system, connect the TS con-

nector of the IR-AC coupling cable (provided) to the IR output port of the control system and connect the TRS

connector of the IR-AC cable to the IR IN to either transmitter or receiver of the DL-HDE100-H2.

DL-HDE100-H2

is capable of passing IR signals between 33 and 55 KHz. To prevent damage

DL-HDE100-H2 Owners Manual